描述
Refurbished Advanced Energy RFX-600 RF Generator Description: The RFX 600 is a two-stage power generator using a Fetpower modular power amplifier and a switchmode dc power supply for main power and control. The RFX is designed for 80% reflected power capability. It regulates output power using either forward power or dc bias of the load. Its features allow it to be used alone or combination with other supplies (through common exciter mode) in such configurations as RF with bias, RF with dc bias, and dc with RF bias. Specifications: Power Output: 600 watts maximum into a 50 ohm load. Harmonic Distortion: All harmonics are more than 50 dB below the fundamental. Noise, hum and ripple are down by 30 dB or greater below the fundamental. Frequency: 13.56 MHz ±10% Output Impedance: 50 ohms Output Power Regulation: ±3% of power setting for any load VSWR variation from 1:1 to 10:1 resistive (within auto protection limits). Load Mismatch Tolerance: Continuous operation into any load mismatch without failure. Pulsed Operation: Frequency range from zero to 10 kHz maximum. Rise and fall times are less than 2.0 microseconds. Pulsing input is CMOS 15 V compatible. Unit is capable of simultaneous and independent RF amplitude control and pulse operation. Protection: Automatic foldback occurs when voltage, current or dissipation exceeds preset limits. Unit capable of up to 400 watts reflected power mismatch without foldback. Unit is completely protected from hardware damage due to open outputs. RF Power Control: 0 to 600 watts with front panel control or remote 0 to 5 volt command. Maximum Power Limit: Adjustable limit from zero to maximum output prevents excessive output during remote operation. Front panel setscrew adjustment. Setting may be observed on front panel digital display. Automatic Forward Power Setting: 0 to 600 watts internally or externally controlled. Efficiency: Variable switchmode dc input combined with Class D Fetpower output provides a minimum 60% overall efficiency from 100 watts to 600 watts output into 50 ohms resistive. Regulation: Forward power or dc bias of the load. Input Power: 230 VAC ±10%, single phase, 50/60 Hz Dual Supply Operation: Unit may operate either as master or slave or independent mode by logic level selection through a user connector on the rear panel (common exciter - "CEX TOGGLE"). Remote Operation: A user connector (25-pin subminiature D-type) is provided on the rear panel to allow remote operation or computer interface. Diagnostic Connector: Rear panel subminiature (15-pin subminiature D-type) connector provide sufficient information to troubleshoot a problem to an internal module level without the need to open the cover. Cooling: Forced air; maximum inlet ambient temperature is 40°C. Temperatore monitors protect the unit from fan failure or airflow blockage. Dimensions*: 6.97" H x 8.50" W x 17.75" D (17.70 cm x 21.59 cm x 45.09 cm) Weight: 26.5 lbs (12 kg) RF Output Connector: Type "N" Notes: *: Add 2" (5.08 cm) to include removable rack ears配置
The Unit's Serial Number Tag Reads: Model Number: 3155002-022C Serial Number: 51204 Revision: COEM 代工型號說明
Two-stage power generator文檔
無文檔
類別
Power Supplies
上次驗證: 超過60天前
關鍵商品詳情
條件:
Refurbished
作業狀態:
Deinstalled / Uncrated
產品編號:
125943
晶圓尺寸:
未知
年份:
未知
Logistics Support
Available
Transaction Insured by Moov
Available
Refurbishment Services
Available
類似上架商品
查看全部
ADVANCED ENERGY
RFX-600
類別
Power Supplies
上次驗證: 超過60天前
關鍵商品詳情
條件:
Refurbished
作業狀態:
Deinstalled / Uncrated
產品編號:
125943
晶圓尺寸:
未知
年份:
未知
Logistics Support
Available
Transaction Insured by Moov
Available
Refurbishment Services
Available
描述
Refurbished Advanced Energy RFX-600 RF Generator Description: The RFX 600 is a two-stage power generator using a Fetpower modular power amplifier and a switchmode dc power supply for main power and control. The RFX is designed for 80% reflected power capability. It regulates output power using either forward power or dc bias of the load. Its features allow it to be used alone or combination with other supplies (through common exciter mode) in such configurations as RF with bias, RF with dc bias, and dc with RF bias. Specifications: Power Output: 600 watts maximum into a 50 ohm load. Harmonic Distortion: All harmonics are more than 50 dB below the fundamental. Noise, hum and ripple are down by 30 dB or greater below the fundamental. Frequency: 13.56 MHz ±10% Output Impedance: 50 ohms Output Power Regulation: ±3% of power setting for any load VSWR variation from 1:1 to 10:1 resistive (within auto protection limits). Load Mismatch Tolerance: Continuous operation into any load mismatch without failure. Pulsed Operation: Frequency range from zero to 10 kHz maximum. Rise and fall times are less than 2.0 microseconds. Pulsing input is CMOS 15 V compatible. Unit is capable of simultaneous and independent RF amplitude control and pulse operation. Protection: Automatic foldback occurs when voltage, current or dissipation exceeds preset limits. Unit capable of up to 400 watts reflected power mismatch without foldback. Unit is completely protected from hardware damage due to open outputs. RF Power Control: 0 to 600 watts with front panel control or remote 0 to 5 volt command. Maximum Power Limit: Adjustable limit from zero to maximum output prevents excessive output during remote operation. Front panel setscrew adjustment. Setting may be observed on front panel digital display. Automatic Forward Power Setting: 0 to 600 watts internally or externally controlled. Efficiency: Variable switchmode dc input combined with Class D Fetpower output provides a minimum 60% overall efficiency from 100 watts to 600 watts output into 50 ohms resistive. Regulation: Forward power or dc bias of the load. Input Power: 230 VAC ±10%, single phase, 50/60 Hz Dual Supply Operation: Unit may operate either as master or slave or independent mode by logic level selection through a user connector on the rear panel (common exciter - "CEX TOGGLE"). Remote Operation: A user connector (25-pin subminiature D-type) is provided on the rear panel to allow remote operation or computer interface. Diagnostic Connector: Rear panel subminiature (15-pin subminiature D-type) connector provide sufficient information to troubleshoot a problem to an internal module level without the need to open the cover. Cooling: Forced air; maximum inlet ambient temperature is 40°C. Temperatore monitors protect the unit from fan failure or airflow blockage. Dimensions*: 6.97" H x 8.50" W x 17.75" D (17.70 cm x 21.59 cm x 45.09 cm) Weight: 26.5 lbs (12 kg) RF Output Connector: Type "N" Notes: *: Add 2" (5.08 cm) to include removable rack ears配置
The Unit's Serial Number Tag Reads: Model Number: 3155002-022C Serial Number: 51204 Revision: COEM 代工型號說明
Two-stage power generator文檔
無文檔